This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
usersguide:runningonvirtualbox [2016/12/14 17:15] stefanschroeder [X.org] |
usersguide:runningonvirtualbox [2018/01/09 03:04] nnyby [Virtual Machine Setup] remove unnecessary setup step: utc time |
||
---|---|---|---|
Line 3: | Line 3: | ||
This page describes the process of installing MINIX 3 on VirtualBox. | This page describes the process of installing MINIX 3 on VirtualBox. | ||
+ | Confirmed to work with | ||
+ | |||
+ | ^ VirtualBox ^ Minix ^ Host-OS ^ Notes ^ | ||
+ | | 4.3.36 | 3.3.0-3234ff | Debian 3.16.36 | X not installed | ||
+ | | 4.3.36 | 3.4.0rc2-373b793 | Debian 3.16.36 | X works ok | ||
+ | | 5.2.4 | 3.4.0rc6 | Debian 10 (buster)| | ||
===== Preliminaries ===== | ===== Preliminaries ===== | ||
Line 19: | Line 25: | ||
- Pressing **Create** will create the Disk Image and the Virtual Machine that we will run. | - Pressing **Create** will create the Disk Image and the Virtual Machine that we will run. | ||
- Now select **MINIX3** in the list on the left. | - Now select **MINIX3** in the list on the left. | ||
- | - Click the **Settings** button on the main screen of VirtualBox. Then click on //System// in the list on the right and tick the **Hardware Clock in UTC Time** checkbox. | ||
- Click OK, and you are now ready to install MINIX 3! | - Click OK, and you are now ready to install MINIX 3! | ||
+ | |||
+ | Troubleshooting: | ||
+ | |||
+ | - If the installer fails to detect the virtual hard disk attached to a SATA controller, reconfigure the machine and attach the disk to the IDE controller. Also, make sure that the CDROM is attached to the IDE controller as well. (VirtualBox 5.1.22) | ||
===== Installation ===== | ===== Installation ===== |